top of page
DA2-200
 Servo Driver, three phase 220V 2.0KW, General Type
 

DA2-200

$626.00Price
  • Power 2kW
    Input Power three phase 200-240V 
    Cooling Method Fan Cooling
    Main circuit control mode Sinusoidal PWM drive
    Feedback 20Bit INC/17Bit INC
    Control Mode ①Position control, ②Speed control, ③ Torque control, ④Position/speed mode switch, ⑤Position/torque mode switch, ⑥Speed/torque mode switch, ⑦Positioning operation mode
    Position Control :Max input pulse frequency Low speed pulse: Max input 500kHz(Line Drive input), Max input 200kHz (Open Collector Input)
    High Speed pulse: Max input 4MHz(Line Drive input)
    Position Control :Command pulse input mode ①Command pulse/command signal , ②Forward rotating pulse and reverse rotating pulse, ③A/B phase orthogonal pulse
    Position control :Command control mode ①External command pulse input control, ②Internal position data control
    Electronic Gear Electronic Gear N/M times(N:1~4194304)/M:1~4194304) 
    Torque Limitation Parameter control(Forward rotating and reverse rotating can be set respectively)/External analog torque control
    Speed control Analog command input VREF  0~±10VDC
    Speed control Variation Rate ±1r/min or below (load range 0~100%)
    Speed control: Acceleration and deceleration time setting Acceleration time and deceleration time can be set respectively, and have two groups, and can accelerate and decelerate with S curve
    Speed control mode External analog input/Internal speed setting
    Speed control/Torque Limitation Parameter control(Forward rotating and reverse rotating can be set respectively)/External analog torque control
    Torque control /Analog command input TREF  0~±10VDC
    Torque control/Torque Limitation Parameter control/External analog speed limitation
    Input EI1~EI8 8 lines input, the function can be set freely according to the parameter
    Output Encoder pulse outputs by frequency division, A/B/Z phase output by line drive and open collector (Total 6 lines) EOUT1~EOUT5 5 lines output, the function can be set freely according to the parameter
    Monitor Feedback speed, reference speed, reference torque, motor current, feedback of current location , Location Difference, reference pulse frequency, Feedback Pulse Accumulation, Reference Pulse Accumulation, VREF input voltage, TREF input voltage, input terminal signal, output  terminal signal etc
    Protection(Alarm display) Overcurrent(Oc1,Oc2),Over speeding (oS), Overvoltage(Hv), Memory Error (dE),Encoder Error(Ec),Overload(oL1,oL2) Main circuit under voltage(Lu),EI Repeat(ctE),Deviation overflow (oF),Servo motor drive overheat(AH) etc.
    Site location Indoors (Avoid direct sunlight), No corrosive gas (Avoid smoke, methane)
    Ambient Temperature 0~50 ℃(When the ambient temperature is higher than the required one,please introduce air circulation)
    Relative humidity RH 90% lower (No condensation)
    Atmospheric pressure 86~106kPa
    Vibration ≤0.5G
bottom of page